Installation Guide

Form 42-47-00-00 version 7

CABLE REPLACEMENT INSTRUCTIONS continued

1) Feed the

crimped end of the

new cable under

anchoring “V” from

the bottom of the

“A” Section

2) Feed into top

of “B” Section.

3) Feed out

through near end

of sheave pocket

4) Feed into

slot in “B”

Section

5) Feed out the

bottom sheave

pocket on the “B”

Section on the end

nearest the bottom.

“A” section

“B” section

1. Loosen the cable from the mooring tab on the winch and

pull it out from the winch drum. BE CAREFUL! A worn cable

can have frayed strands. Wearing gloves will help protect your

hands.

2. Pinch the two telescoping sections together and lift them

out as a unit. Pulling the cable will help to raise them.

3. Remove the two telescoping sections completely from the

frame housing. Pull the cable completely out from the frame

along with them. Remove the “A” Section from the “B” Section

as shown below. BE CAREFUL for loose strands or frays on

the cable.