Installation Guide

5
Form 42-47-00-00 version 7
© 2018 Paragon Pro Manufacturing Solutions, Inc. All Rights Reserved
11. Pull the slack cable through the sheave pocket and slide the
telescoping sections into the frame housing. As the telescoping
sections lower into the frame, the slack cable will be drawn back
up over the sheave.
13. Rotate the winch in the direction shown to take the slack out
of the cable.
12. Feed the crimped end of the cable through the hole in the
winch drum and secure it behind the mooring tab by hand pulling
the cable snug as shown.
10. To reinstall the assembled telescoping sections, feed the
crimped end of the cable through the frame sheave pocket from
the top and over the top of the sheave as shown.
Front View
DO NOT feed the
cable under the cable
sheave on the frame
as shown in this photo!
X
Yes - Correct
Feed the cable
over the top of
the sheave
like this.
NO!! - WRONG
DO NOT feed the cable
under the sheave at this
point!!
WARNING
The cable MUST feed down from the top of the frame housing
and over the top of the sheave exactly as shown in step 7 in
order to function properly. Failure to install the cable correctly
as shown can cause wearing of the cable for which it is not
designed which can result in failure of the cable. Failure
of the cable while the lift is raised will result in a sudden
and rapid lowering of the lift and the load possibly resulting
in serious property damage and / or serious bodily injury.
CABLE REPLACEMENT INSTRUCTIONS continued