Acculink DSU/CSU Data Service Unit Models 3160-A4, 3161, 3164-A2, and 3165-A4 Operator's Guide

4. Configuration

3160-A2-GB24-10 March 2001

4-15

Setting the IP Address

The IP address is the address used by the SNMP or Telnet system to access the

DSU/CSU (see Appendix G,

IP Network Addressing Scenarios

). For DSU/CSUs

using PPP, the IP address can be negotiated if the network device (e.g., router or

SNMP manager) supports such negotiation. The IP address is composed of four

bytes, each represented by three decimal digits (

xxx.xxx.xxx.xxx

The IP address is set for the MODEM port, the COM port, or, for the Model 3164

only, the AUX port (with LAN Adapter or daisy chain), depending on which one has

been chosen as the SNMP or Telnet communication link. The example below

shows an IP address of 010.155.111.222 being set for the COM port. You can use

the same principles to assign any valid value. Valid values are 000–126 and

128–223 for the first byte, and 000–255 for the remaining bytes.

Procedure

To assign an IP address to the COM port:

1. From the top-level menu screen, select Cnfig.

2. Select the configuration option set to be copied into the Edit area by using the

appropriate Function key. Use the scroll keys, if necessary.

3. Select Edit.

4. From the Edit screen, press the key until the Mgmt selection appears on

the screen.

5. Select Mgmt.

6. From the Mgmt Config screen, select Gen.

7. Press F1 (Next) until the Com IP Adr configuration option appears.

Edit:

User Alarm Mgmt

Mgmt Config:

Gen Trap