user manual

8021-A2-GZ40-20 November 2000
3
Installing the SCM Card
Procedure
To install the Hotwire SCM Card in Slot A of the GranDSLAM chassis:
1. If there is a filler plate covering the slot, remove it.
2. Remove the yellow screw covers.
3. Insert the card into the card guides of the slot on the chassis.
4. Carefully slide the card into the slot. Lift the insertion/ejection levers away from
the faceplate until the card begins to engage the connectors on the backplane.
Then press in on the insertion/ejection levers until the card is fully seated.
5. Verify that the OK SYSTEM indicator on the card’s faceplate is ON (winking
green). If not, refer to the appropriate Hotwire GranDSLAM Installation Guide.
6. Secure the card by fastening the screws on each end of the faceplate. This is
required to maintain proper gasket pressure on the faceplate as well as proper
air flow.
7. Attach appropriate connections (e.g., DS3, OC3, etc.) to the uplink.
NOTE:
The IMA uplink has a RJ48M 50-pin connector. See
IMA Uplink Card
Connector Pinouts
on page 4 for more information.