Instructions / Assembly

Warning:
Rocks and other sharp objects may puncture the Clean Park
®
. To avoid punctures,
regularly remove debris by sweeping with a soft bristle broom.
Cleaning Instructions:
Remove one or more of the end pieces closest to the garage door. Be careful not to puncture
or cut the vinyl sheeting with the edge of the top piece as you pull it off. Sweep the Clean
Park
®
with a soft bristle broom. Hose off the Clean Park
®
. Use a soft bristle broom to push
water towards the open area, off of the Clean Park
®
. Only a mild dish soap may be used on
the Clean Park
®
. Do Not Use Solvents, Harsh Chemicals, Abrasive Cleaners or Bleach.
Discoloration of the vinyl sheeting may occur over time and does not affect the integrity of
the material.
1. Sweep or vacuum garage oor. Repair or cover (with duct tape) any cracks in garage oor.
2. Lay out all of the edge pieces before beginning assembly.
3. See gure 1. Starting at the edge closest to the street, attach the long V-shaped pieces to the
left and right sides.
4. See gure 2. On the end farthest away from the street, cut down vinyl sheet so it protrudes
1½” inches beyond the last long V-Shaped side piece.
NOTE: All Clean Parks
®
can be shortened by 2’ increments just by omitting long V-Shaped side
pieces and cutting the vinyl sheet, as described above.
5. See gure 3. On the side farthest away from the street, attach the short V-Shaped pieces.
6. See gure 4. Next, lay all of the at parts, with the mushroom shaped prole, on the oor
under the edge of the vinyl sheeting.
7. See gure 7. The ramp sections snap on top of the vinyl sheeting, onto the at parts with
the mushroom shaped prole. See gure 5 & 6. Each kit has two ramp sections with a
rounded corner. Position the rounded corner next to the long V-shaped side pieces. Snap
down the ramp sections with the rounded corners, on the left and right sides of the Garage
Mat. Next, snap down the remaining top ramp sections.
Assembly Instructions
Figure 2
Figure 3
Figure 5
Figure 4
Figure 1
Figure 7
Figure 6
Lay out all the edge pieces
before beginning assembly.
Cold Weather Assembly Tip
In extremely cold weather, the vinyl sheet may become stiff, making it difcult to attach the edge
pieces. To soften up the vinyl sheet, bring the vinyl sheet inside the house and allow it to warm up to
room temperature.
Or
Use a hair dryer and blow warm air along the vinyl sheet, as you attach each edge piece.
DO NOT USE A HEAT GUN