- Compumotor OEM650/OEM650X OEM350/OEM350X Drive and Drive/Indexer User Guide
INSTALLATION • OEM650/OEM650X
4
Option Description
-DS23 Double Shaft Size 23 Motors
-DS34 Double Shaft Size 34 Motors
Table 2-4. Double Motor Shaft Option
The following accessories are available.
Accessories Part Number
OEM650/OEM650X User Guide 88-013157-02
OEM Series Software Ref. Guide 88-013785-01
Low Current Heatsink OEM-HS1
High Current Heatsink OEM-HS2
Table 2-5. OEM650/OEM650X Accessories
Evaluation kits
Evaluation kits include all items necessary to evaluate the OEM650
(OEM650-EK) and OEM650X (OEM650X-EK) in a simulated produc-
tion environment. The kits are intended to be used to prototype a
machine or operation before production units are purchased. The
following items are included in an evaluation kit. Motors must be
ordered separately—they are not included in the kit. If a component
is missing, contact Compumotor's Customer Service Department.
Part Part Number
Drive or Drive/Indexer OEM650
or
OEM650X
OEM650/OEM650X User Guide 88-013157-02
OEM Series Software Ref. Guide 88-013785-01
High Current Heatsink OEM-HS2
Ship kit Items:
❐ Resistors (for current selection—the following types are available)
• 21.0KΩ 1% Resistor 12-008319-01
• 5.76KΩ 1% Resistor 12-008265-01
• 15.8KΩ 1% Resistor 12-008307-01
• 2.05KΩ 1% Resistor 12-008222-01
• 12.7KΩ 1% Resistor 12-008298-01
• 0.00KΩ 5% Resistor 12-003645-01
• 9.53KΩ 1% Resistor 12-008286-01
• 4.87KΩ 1% Resistor 12-008258-01
• 1.27KΩ 1% Resistor 12-008202-01
❐ Screwdriver 58-013155-01
❐ 25-Pin D Mating Connector 43-001989-01
❐ X-Ware Support Disk (OEM650X-EK Only)
• 3 1/2" Disk 95-013066-01
• 5 1/4" Disk 95-013067-01
Table 2-6. OEM650 Series Evaluation kit Contents
Quick Test (OEM650/OEM650X)
Use the following steps to set the drive’s jumpers, wire the unit, and
test your system. You will need the following tools:
❐ Needle nose pliers or tweezers
❐ Flathead screw driver (1/10")