Installation Manual

Page 8

(800)-321-2343 www.onqlegrand.com

Selective Call Patio Unit(s)

The procedure to trim-out the Patio Unit(s) is as follows:

• As shown in Figure 6, the first step to installing the

Selective Call Patio Unit is to place the included

weather proofing rear gasket against the gang or back

box, and secure the gasket in place with the included

mounting bracket.

NOTE: Insure that the mounting bracket is installed

with the center tab pointed up, as the Patio Unit will

be “hung” from this tab in a later step.

NOTE: There are slotted holes in the mounting

bracket to allow for leveling of the Patio Unit in case

the gang or back box was installed off level.

• Use the four provided screws to attach the mounting

bracket to the gang or back box.

• Pull the Cat 5 cable from the enclosure through the mounting bracket and terminate the cable

with an RJ45 plug and insert the plug into the RJ45 jack on the rear of the Patio Unit (see

Figure 7). Follow the T568A standards described in Figure 3.

• Hang the Patio Unit from the top tab on the mounting bracket insuring the front gasket is in

place and against the mounting bracket.

• Use the provided 1/16” allen wrench to tighten the two set screws at the bottom of the Patio

Unit.

Figure 6

rear

gasket

center tab

mounting

bracket

Figure 7

front gasket

RJ45

jack

set screws