Installation Manual

Page 9

(800)-321-2343 www.onqlegrand.com

Selective Call Door Unit(s)

The procedure to trim-out the Door Unit(s) is as

follows:

NOTE: Make sure that the included weather

proofing gasket is placed as shown in Figure 8.

• As shown in Figure 8, the first step to

installing the Selective Call Door Unit is to

place the included rear gasket against the

gang or back box, and secure the gasket in

place with the included mounting bracket.

NOTE: Insure that the mounting bracket is

installed with the center tab pointed up, as

the Door Unit will be “hung” from this tab in

a later step.

NOTE: There are slotted holes in the mounting bracket to allow for leveling of the Door

Unit in case the gang or back box was installed off level.

• Use the four provided screws to attach the mounting bracket to the gang or back box.

• Pull the Cat 5 cable from the enclosure through the mounting bracket and terminate the cable

with an RJ45 plug and insert the plug into the RJ45 jack on the rear of the Door Unit (see

Figure 9). Follow the T568A standards described in Figure 3.

• Hang the Door Unit from the top tab on the mounting bracket insuring the front gasket is in

place and against the mounting bracket.

• Use the provided 1/16” allen wrench to tighten the two set screws at the bottom of the Door

Unit.

NOTE: There is a four position terminal

block on the rear of the Door Unit that

can be utilized for two different

purposes (see Figure 10). The CHIME

output is a normally open dry contact

closure used to ring a customers 3

party door chime when the Door Unit

button is pressed. The SENSOR input

is reserved for a future application.

rear

gasket

center tab

mounting

bracket

Figure 9

Figure 8

RJ45

jack

front gasket

Figure 10

set screws