Installation Manual

Page 17
301 Fulling Mill Road, Suite G ©Copyright 2008 by On-Q/Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800)-321-2343 www.onqlegrand.com
Disc. Settings
The Discovery Settings option, selected from the Installer Setup screen (see Figure 42) is an
option screen that allows the installer to turn ON the unit beep that occurs when units are
discovered. It is turned OFF by default (see Figure 43) so as not to disturb homeowners at
night if there is a temporary power outage and restoration of power. When turned ON, each unit
in the system will beep as it is discovered upon power initialization.
Room Options
The Room Options Installer Setup option, selected from the Installer Setup screen (see Figure
44) is an option screen that allows the installer to adjust the contrast of the Room Unit’s LCD
display. This option is set at the factory (see Figure 45) and should not need to be adjusted,
but if desired, press the talk/select button, and use the up/down arrow buttons to adjust the
contrast of the display to taste.
Figure 42 Figure 43
ROOM1
INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
ROOM1
INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
ROOM1
DISC. OPTIONS
Discovery Beep:
BACK
OFF
ROOM1
DISC. OPTIONS
Discovery Beep:
BACK
OFF
Figure 44
Figure 45
ROOM1
INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
ROOM1
INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
ROOM1
ROOM OPTIONS
Contrast
Contrast
BACK
>
Contrast
ROOM1
ROOM OPTIONS
Contrast
Contrast
BACK
>
Contrast