Use and Care Guide

      
ASSEMBLY
TABLE ASSEMBLY
1
Table Top
A

8x30mm Studs
J
onto the Table Top.
 
 
Hardware Used:
2
Legs
B
over the 8x30mm Studs
J
and
secure in position using 4 - 8mm Washers/Spring
Washers/Nuts
H
Washer, then Spring
Washer, last Nut
 
Hardware Used:
Washer/Nut

Turn the assembled Table Top/Legs over. Attach
the Round Leg Support
C
to the Legs
B
and insert
6x35mm Bolts
G
through the holes on the Leg Support and
holes on each Leg, then slide 6mm Washer/Spring Washer/
Nut over the end of each BoltWasher, then
Spring Washer, then Nut
Hardware Used:
  
Washer/Nut
PREPARATION
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts are missing,


J
J
A
B
H
A
G
A
B
C
I
1
2
3