Data Sheet

LA6-W18D-25_26
6. Changing Data
With the “EDITOR for LA series” application software, setup data can be changed and transmitted into this product.
• Necessary Items
• This product
•
P
ersonal Computer (with all hardware operating normally)
•
M
icro-USB Cable for Charging/Data Transfer (* USB-A male to USB Micro-B male is not included with this products)
•
“EDIT
OR for LA series” Application Software
(Visit our homepage at http://www.patlite.com/ to download it.)
Supporting OS: Windows 7 (32/64 bit), Windows 8 (32/64 bit), Windows 8.1 (32/64 bit), Windows 10 (32/64 bit)
• Transfer Procedure
A. Product changes to standby status in which all signal inputs are “OFF.”
(Power supply input can be ON or OFF, whichever is easier)
B.
Open the USB C
over to the product, use the Micro-USB Cable to connect the product to the personal computer.
C.
Click the
“Transmission” button in the “EDITOR for LA series” application software.
D.
F
rom the start of data transfer, it takes about 15 seconds before the “Transfer was completed” prompt is displayed.
E.
R
emove the Micro-USB cable and close the USB Cover completely.
24V DC Class2
This device complies
with Part 15 of the
FCC Rules.
Operation is subject
to the following two
conditions:
(
1
)
this device may
not cause harmful
interference,and
(
2
)
this device must
accept any interference
received, including
interference that may
cause undesired
operation.
Personal
Computer
LA6 (back)
Micro-USB cable
（
Not included with this product.
）
USB Cover
Micro-USB Connector
(Micro-B Female)
Note
•
I
f the power supply input to the product is set to ON, the group operation test can be checked by clicking the “preview”
button in the “EDITOR for LA series” application software.