Installation Instructions

ManualsBrandsPatriot Lighting Elegant Home ManualsFlush Mount LightsPatriot Lighting® Elegant Home Blake Antique Silver 5-Light Semi-Flush Mount Ceiling Light

1. Assemble the center column (B)

to the bulb assembly (A) then cover

it with the metal tube (C), top cap

(D) and Canopy (E) and secure with

large washer (GG), lock washer (FF)

and nut (EE).

2. Attach mounting unit (AA) to the

junction box (not included) with

mounting screws (BB). Note: the

preinstalled support screws on the

mounting unit (AA) should protrude

out away from the junction box.

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with package contents

list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble, install or operate the product.

Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters, Safety Glasses,

Ladder, Wire Stripper

• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC). Contact your

municipal building department to learn about your local codes, permits and/or inspections.

• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician before

installation.

• Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use a fixture in a

two-wire system that is not grounded. If you are not sure your lighting system has a grounding means, do not attempt to install this

fixture. Contact a qualified, licensed electrician for information with regards to proper grounding methods as required by the local

electrical code in your area

• If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type and electrical rating

required.

CAUTION

WARNING

•

Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit

breaker).

• Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface

having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury or death from electric

shock.

Please read and understand this entire manual before attempting to assemble, operate or install the product.

3. Connect the copper wire on the

light fixture to the mounting unit

(AA) by securing it with the

preinstalled ground screw.

4. Connect the black to black

(power), the white to white (neutral)

and copper wire to ground wire with

the wire nuts (CC) and secure with

electrical tape (not included). Helpful

Hint: If wires out of the fixture are

the same color, attach the side with

markings or letters to black (positive)

and the other to white (neutral).

5. Secure the light fixture to the

junction box by placing the canopy

(E) over the preinstalled support

screws on the mounting unit (AA) and

securing it with the ball nuts (DD).

IInstall the included 60-watt max.

E26 incandescent bulbs (HH).