Installation Instructions

PAGE: 9 / 10 PAGE: 10 / 10
To clean the fixture, turn off the power, wait for it to cool, and wipe the fixture
with a clean, soft cloth.
ASSEMBLY INSTRUCTIONS
CARE AND MAINTENANCE
TROUBLESHOOTING
- Check wiring connections to fan.
- Check fuses and circuit breakers.
- Check wiring connections in switch housing.
CAUTION: Turn power off for last two items.
- Check to make sure that all screws in motor housing are snug.
- Check to make sure that blade bracket screws are tight.
- Check to make sure that marrettes in switch housing
are not rattling against wall of switch housing.
- If fan has a light kit make sure switch housing
screws and set screws are tight.
- Some fan motors are sensitive to signals from solid state
variable controls. If solid state controller is used, change to
an alternative control. (See a representative for a list of
available controls.)
- Allow a 24 hour break in period to eliminate most noises.
- Check that all blades are screwed firmly into blade brackets.
- Check that blade brackets are secured firmly to motor.
- Check distance from tip of blades to ceiling.
- Check distance between blade tip to blade tip. All
measurements should be equal. Loosen blade screws and
position blade until even then re-tighten.
- Check that the downrod hemisphere notch is engaged in canopy.
- Check to make sure that jam screws in downrod are tightened.
- Make sure canopy and mounting bracket are tightened securely
to wooden joist.
- Make sure warpage has not occurred in wooden blades. If so,
contact the customer service department for replacement parts.
TROUBLE SUGGESTIONS
1. Fan will not start
2. Fan sounds noisy
3. Fan wobbles or
shakes excessively.
ASSEMBLY INSTRUCTIONS
6. ENGAGE HEMISPHERE (Downrod Mount Only)
- The hemisphere needs to be engaged before receiver will fit into mounting bracket.
- Carefully rotate fan assembly until groove in hemisphere locks over tab of canopy assembly.
WARNING: Failure to seat tab in groove could cause damage to electrical wires and
possible shock or fire hazard.
Downrod
Hemisphere
Groove
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket faces towards
the top of the slope. Depending on the slope, a longer downrod may be required to prevent
fan blades from hitting the ceiling.
Bulb
Light Kit
Light Kit
Nut
Decorative
Cover
Cap Nut
Fiber Washer
Glass
Crystal
Stud
7. LIGHT KITS
WARNING: Ensure that all connections, set screws and screws are securely tightened
before the next step.
WARNING: BE SURE TO TURN OFF POWER BEFORE INSTALLING
Cover
a.
b.
a. b.
- Secure the stud onto the light kit.
- Install proper wattage and type of bulb identified on light kit.
- Secure the glass crystal cover to light kit with fiber washer, nut, decorative cover and cap nut
as shown in figure.
(A)
(B)
(B)
Washers
(A)