Installation Instructions

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
SAFETY INFORMATION
Page 2 of 3
190614
ASSEMBLY INSTRUCTIONS
Turn off the power at fuse or circuit box.
1. Secure cross bar unit (AA) to the
outlet box using two mounting
screws (BB). Adjust the length
of fixture mounting screws on the
cross bar unit (AA) if necessary.
Note: Make sure that the
fixture mounting screws are
lined up horizontally to make
the fixture level.
1
Outlet Box
Fixture Mounting Screw
AA
BB
2. Pull out the source wires from the
outlet box. Make wire connections
using wire connectors (CC) as
follows:
---Connect the hot wire (black
insulation) from the fixture to
the black wire from the power
source.
---Connect the neutral wire (white insulation) from the
fixture to the white wire from the power source.
---Attach the fixture ground wire (bare wire) to the cross
bar unit (AA) with the green ground screw, then
connect it to the house ground wire with the wire
connector (CC).
Carefully put all of the wires back into the outlet box.
AA
CC
2
Outlet Box
Green Ground
Screw