Installation Instructions

GROUND

WIRE

* 48”

REQUIRED

LINE VOLTAGE-

CABLE

LINE VOLTAGE CABLE

BASE SECTION

CAP NUTS

SPRING

WASHERS

5.1 Insert the line voltage cable inside the base and mount the base onto

the three (3) anchor bolts. Secure the base with the three (3) spring

washers and cap nuts provided.

5.2 Pass the wire exiting each arm through the holes in the spreader.

Using the 6 (M5 x 14) screws and 5mm teeth washers, secure each of

the arms onto the spreader using the provided 8mm tool.

5.3 Join all three (3) arm wires and connect to the main streetlight

cable using wire nuts.

5.4 Attach the post cap on top of the spreader with the three (3)

M4 x 12mm screws and 4mm teeth washers.

5.5 Attach the spreader to the top post using the provided 3 set screws

(M6 x 9.5).

5.6 Attach the top and mid post sections by screwing them together in

a clockwise direction. Also, making sure to feed the streetlight cable

from the spreader down through the post sections.

5. Wiring and assembly

POST CAP

M4 x 12mm

SCREWS

ARM

STREETLIGHT

CABLE