Installation Instructions

6
Canopy
Round Hole
Trim Ring
Mounting
Bracket
Screw
J-shaped Slot
Downrod Pin
Yoke
Downrod
Downrod Clip
Set Screw
Tab
Slot
Downrod
Mounting
Bracket
Black (Hot)
Wire Connector
White (Neutral)
Bare/Green (Ground)
Black Blue White Green
WARNING: Do NOT
wire the fan motor to a
variable-speed (dimmer)
wall control.
ASSEMBLY INSTRUCTIONS
7
5
6
5. Insert the downrod into the yoke and reinstall the
downrod pin and downrod clip. Then retighten the two
set screws.
Note: With wires extending out of the downrod, measure
8 inches of lead wire and cut the excess wire with wire
cutters (not included). Then strip 1/2” of insulation from
the end of each wire.
6. Lift the downrod into the mounting bracket. Rotate
the downrod until the tab in the mounting bracket is
seated in the slot in the downrod ball.
WARNING: The fan and/or downrod should not rotate
in the mounting bracket if installed correctly. Failure
to align the slot in the downrod ball with the tab on
the mounting bracket may result in fan falling causing
serious injury or death.
7. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the white wire from the fan to the white
(neutral) supply wire.
• Connect the black and blue wires from the fan to the
black (hot) supply wire.
• Connect the green wire from the downrod and the
mounting bracket to the bare/green (ground) supply wire.
Note: If there is a second hot/power wire coming from the
outlet box, connect it to the blue (light power) fan wire for
separate light and fan control.
Important: After the connections have been made, the
connected wires should be turned upward and pushed
carefully up into the outlet box. Place the black and white
wire connections on opposite sides of the outlet box.
8. Raise the canopy, align the two mounting bracket
screws with the J-shaped slots in the canopy. Then turn
the canopy clockwise until the mounting bracket screws
are completely engaged in the J-shaped slots. Install
the two previously removed mounting bracket screws
into the round holes. Securely tighten all four mounting
bracket screws. Lift the trim ring over the canopy and turn
clockwise until it is locked into position.
8