Installation Instructions

7
Blade Screw
Blade Washer
Rubber Washer
Blade
Blade Arm
Motor
Block
Motor Screw
Motor
Motor Screw
Adapter
Plate
Adapter
Plate Screw
Blade Arm
Motor
ASSEMBLY INSTRUCTIONS
11
10
9. Remove the ve motor blocks and ten motor screws
from the underside of the motor. Discard the motor
blocks, but keep the motor screws for installation of the
blade arms.
10. Partially insert three blade screws along with blade
washers and rubber washers through the blade and
into the blade arm. Tighten each blade screw, starting
with the one in the middle. Repeat this step for the
remaining blades and blade arms.
9
11. Install the blade arm to the underside of the motor
assembly with previously removed motor screws. Tighten
each blade arm completely before moving to the next.
12
12. Remove one and loosen the other two adapter plate
screws on the adapter plate. Lift the tter plate onto
the two adapter plate screws and turn in a clockwise
direction. Then insert the previously removed adapter
plate screw into the round hole. Tighten all three screws
to secure the tter plate.