Installation Instructions

5
ASSEMBLY INSTRUCTIONS
1
4
3
4. Remove the downrod clip and downrod pin from the
downrod. Then, loosen but do not remove the two set
screws in the yoke of the motor assembly.
2
Mounting
Bracket Screw
Downrod Clip
Set Screw
Yoke
Motor Screw
Motor Assembly
Downrod Pin
3. Remove the ten motor screws from the underside of the
motor assembly and save for blade arm assembly.
2. Loosen all four mounting brackets screws, then
completely remove the two mounting bracket screws
from the round holes of canopy. Set aside screws for later
use. Install the mounting bracket to the outlet box (sold
separately) using the screws and washers provided with
the outlet box.
WARNING: To reduce the risk of re, electric shock,
or personal injury, mount to an outlet box marked
“acceptable for fan support” and use the mounting
screws and washers provided with the outlet box.
1.Turn OFF the electrical power at the main fuse or circuit
breaker.
DANGER: Failure to disconnect the power supply prior to
installation may result in serious injury or death.