Installation Instructions

LED Fixed Rail Luminaires Surface Mount
Model #’s: APRF 120VAC / 60Hz
8060734 Rev 5
2 of 2
Limited Factory Warranty
This fixture is warranted to be free from defects in materials and workmanship when installed and used under normal operating conditions for a
period of 5 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or
components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
REPLACING THE LED DRIVER
IMPORTANT! Do NOT disassemble product. This operation is only for the replacement of a
faulty LED Driver.
IMPORTANT! It is recommended that the replacement of an LED driver be completed by a
qualified electrician.
CAUTION! Turn off main power at fuse or circuit breaker box.
Disassembly:
1. Remove fixture from wall by removing (2) canopy screws
2. Disconnect LED driver power wires from power supply wires in
junction box by removing wire nuts.
3. Separate LED driver from canopy by removing (2) screws.
4. Disconnect (2) driver wires from fixture wires.
NOTE: Mark fixture wires with tape to match black wire with
parallel fixture head wires on one side, and red wire with parallel
fixture head wires on the other side
Discard driver.
Re-assembly
1. Using new LED driver, connect red and black wires to matching
parallel fixture head wires with wire nuts.
2. Re- attach driver to canopy with 2 screws.
3. Connect power supply wires from drive to power supply wires from
junction box.
4. Connect black wire to black wire, white to white and ground(Copper)
to ground (Green or copper)
5. Tuck supply wires in junction box.
6. Connect canopy to junction box/gem bar with (2) screws
7. Restore power to the fixture.