Installation Instructions

ManualsBrandsPatriot Lighting ManualsFlush Mount LightsPayton Satin Nickel LED Flush Mount Ceiling Light

Fig.1

1. Attach the two long screws to the holes on the mounting strap.

Thread them in part way: 2 to 3 turns only.

2. Attach the mounting strap to the outlet box by using two mounting screws.

3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green

grounding screw, then connect it to the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

Long Screw

Key Hole Slot

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST)

3. READ AND SAVE THESE INSTRUCTIONS.

352-5814 / 352-5815

LED module

Coupling

Hex Nut(G)

Threaded Pipe(J)

Hex Nut(G)

Finial(L)

Glass Shade

Washer(F)

Outlet Box

House Grounding Wire

Wire Nut(E)

Long Screw(C)

Ceiling Pan

Mounting Strap(A)

Green Grounding Screw(D)

Mounting Screw(B)

Metal Pad(H)

Decorative Cup(K)

Patriot Lighting

150319

Rubber Pad(I)

Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before

installation, discharge yourself by touching a grounded bare metal surface to remove this

hazard. To avoid damage, do not touch the LED module.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box.

Installation Steps

Mounting Strap (A)

Mounting Screw (B)

Long Screw (C)

Green Grounding

Screw (D)

Wire Nut (E)

Washer (F)

Hex Nut (G)

Threaded pipe (J)

Decorative Cup (K)

Finial (L)

Metal Pad (H) Rubber Pad (I)

Hardware Package (included):

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS 352-5814 / 352-5815 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST) 3. READ AND SAVE THESE INSTRUCTIONS. Warning: LED electronics can be damaged by electro static discharge (ESD)shock.
PAGE 2
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into the key holes. Rotate the ceiling pan until it is locked into place. Then tighten the long screws to secure it. (See Fig.1) NOTE: To prevent electrostatic discharge (ESD) damage to the module electronics, do not touch the LED module on the ceiling pan. 5. Screw the threaded pipe into the coupling, then secure it with a washer and hex nut.