Installation Instructions
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.
Installation Steps
CF38318
For Pendant:
Fixing the silhouette:
1. Attach the nipple-1 to the mounting strap, and then secure with
a washer and a hex nut.
2. Attach the mounting strap to the ceiling box by using two
mounting screws.
3. Choose the certain length of the chain you need, and then weave
the fixture wire and the fixture grounding wire through the chain.
Then connect one end of the chain with the loop by using the loop
lock.
4. Secure the top loop to the nipple-1 tightly.
5. Thread the fixture wire and fixture grounding wire through the
collar, canopy-1, top loop, nipple-1 and mounting strap in order.
6. Connect the other end of the chain with the top loop by using
the loop lock.
7 . Make wire connections with wire nuts:
--- The smooth wire (marked) from fixture to the black wire from power source.
---The ridged wire (unmarked) from fixture to the white wire from power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding
screw. Then connect it to the house grounding wire with the wire nut.
Carefully tuck wires back into the ceiling box.
1. Take out the silhouettes from the package carefully. Loosen the set screws,
but do not unscrew the set screws to prevent them lost.
2. Insert the silhouette to the metal ring, and then fix it toward to the metal ring
with the set screw.(See Fig.1)
3. Repeat Step 2 to finish all the silhouettes fixing.
Note: 1. The end caps divide the silhouettes fixing into three equal
divisions. (See Fig.2)
2. Please according to Fig.2 shown to fix all the silhouettes
whichever you fix first.
CF38318---Page 1
Fixture Wire
Chain
Mounting Screw
Nipple-1
Fixture Grounding Wire
Collar
Top Loop
Canopy-1
Mounting Strap
Green Grounding Screw
Hex Nut
Wire Nut
Washer
Ceiling Box
House Grounding Wire
Loop Lock
Loop-1
Fixture
Suspension Rod
Hook
Glass shade
Hook
Metal Ring
Loop-3
Hook
Loop-2
Loop Lock
NOTE: To convenient for fixing the silhouettes to the metal ring correctly, some symbols had
been marked on the back of each silhouettes, such as P-B, P-C and P-E. Please according
to the order as shown in Fig.2 to fix the silhouettes.
Fig.2
P-B
Metal Ring
End Cap
End Cap
P-C
P-C
P-E
End Cap
Fig.3
Fig.1
End Cap
Set Screw
Clip
Metal Ring
P-C