Model No.
Package Contents: 4 3 7 8 12 11 6 9 Remote Control Instructions X 16 5 10 Installation Instructions 2 1 13 15 14 Unpack your fan and check the contents.You should have the following items. 1.) Hanger Bracket 2.) Canopy 3.) Canopy Cover 4.) Downrod Set (Included Hanger Ball, 6” Downrod, Hanger Pin & Lock Pin) 5.) Downrod Stand Cover 6.) Fan Motor Assembly 7.) Fan Blades (5 PCS) 8.) Blade Brackets (5 PCS) 9.) Connect Plate of Light Kit 10.) Light Kit 11.) Assembly Kit 12.
Exploded View Detail Hanger Bracket Hanger Ball Canopy Canopy Cover Hang Pin Downrod Lock Pin Downrod Stand Cover Fan Motor Assembly Collar Connect Plate of Light Kit Fan Blade Blade Bracket Light Kit LED Bulb Triple Mount Options Ceiling Mount Downrod Mount Slope Ceiling Mount ( Up to 23 degrees) PAGE: 3 / 12 201202
PAGE: 4 / 12 201202
INSTALLATION INSTRUCTIONS IMPORTANT: BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION IN THE SAFETY INSTRUCTIONS AND INSTALLATION INSTRUCTIONS. IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN. SAVE ALL INSTRUCTIONS. NOTE: The fan weight is 18.52 lbs (8.4 kg). Be sure the outlet box you are using is securely attached to the building structure and can support the full weight of the fan. Failing to do so can result in serious injury.
Fig.9 Fig.8 Hanger Bracket Slot Collar Screws Lock Pin Chip (For downrod mount only): Hang the fan on hanger bracket, and make sure the slot of hanger ball is snapped into the chip of hanger bracket exactly. Note: For slope ceiling installation, make sure the slot of hanger ball and the chip of hanger bracket face down. (For downrod mount only): Tighten the two collar screws. Slide lock pin into hanger pin until it is locked into position. Fig.
Fig.12 G Fig.13 Hang Bracket Screw Washer Canopy There are four hanger bracket screws and lock washers. Remove two screws and lock Blade Screw washers from the hanger bracket (one from Washer Blade Bracket each side) and loosen the other two Blade remaining screws. Align the “L shaped” slots of the canopy with the two remaining screws on the hanger bracket and push the canopy upwards to engage the slots and turn clockwise to lock in place. Tighten the Fig.
Fig.16 Fan Motor Assembly Fig.
Fig.21 LIGHT 0N/0FF DIMMER FAN OFF HI MED LOW Install the battery (9V, included) to the transmitter. * Press "HI" button to turn on the fan at high speed. * Press "MED" button to turn the fan in medium speed. * Press "LOW" button to turn the fan in low speed. * Press "FAN OFF" button to turn off the fan. * Press "LIGHT ON /OFF" button to turn on or turn off the light.
.25 .26 .
PAGE: 11 / 12 201202
PAGE: 12 / 12 201202
