Installation Instructions

ManualsBrandsPatriot Lighting ManualsFlush Mount LightsHale Black Flush Mount Ceiling Light

SKU Number: 351-8424

Hale

Flush Mount

Model Number: HALF13BK

HARDWARE CONTENTS Note: Hardware shown not actual size.

Gem Bar

(only use on 4 in Octagon Jbox)

Junction Box

Screws

PACKAGE CONTENTS

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-873-2326

Monday - Friday, 8:00 am-4:30 pm Central Standard Time

Wire Nuts

Acorn Nuts

Summary of content (4 pages)

PAGE 1
SKU Number: 351-8424 Hale Flush Mount Model Number: HALF13BK Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-873-2326 Monday - Friday, 8:00 am-4:30 pm Central Standard Time PACKAGE CONTENTS A B C HARDWARE CONTENTS AA Note: Hardware shown not actual size.
PAGE 2
SAFETY INFORMATION Read all safety precautions and installation instructions carefully before installing or servicing this fixture. Failure to comply with these instructions could result in potentially fatal electric shock and/or property damage. It is recommended that a qualified electrician perform all wiring. This fixture must be wired in accordance with all national and local electrical codes.
PAGE 3
ASSEMBLY INSTRUCTIONS 1. Disconnect electrical power before installing fixture. Attach gem bar (AA) on the junction box (not included) per Fig. A by securing it with two screws (BB). Pre-install another set of screws (BB) to gem bar (AA) onto inner holes toward center allowing 1.25” to protrude above bracket until fixture (A) is ready to be installed. Note: Gem bar is not required and can be discarded if junction box (not included) is of Fig. B type used behind the ceiling.
PAGE 4
CARE AND MAINTENANCE Use a dry or slightly damp clean cloth to wipe the surface of the fixture. Do not use any cleaner with chemical solutions and abrasive pad. If necessary, use a mild soap with water to clean off any dirt or stains. TROUBLESHOOTING 1. The light does not come on at all: a) Make sure the wall switch and circuit breaker are on b) Make sure the wiring is correct 2.