Installation Instructions

081117
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
TL-OPU090
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
Glass Panel
Clip
The Bottom of
Frame
Fig.1
Glass Panel
Clip
Clip
Fig.2
1. Unscrew the bolt nuts and remove the frame
away from the fitter.
2. Gently insert the glass panels into the frame in place,
secure them by pressing the clips. (See Fig.1)
Note: The flat glass should be fastened into position
as shown in Fig.2.
3. Pull out the wires and grounding wire from the post. Make wire connections using the wire nuts:
---The black wire from the fixture to the black wire from the post.
---The white wire from the fixture to the white wire from the post.
---The grounding wire from the fixture to the grounding wire from the post.
Carefully put the wires back into the post.
4. Place the fitter on the post, then secure it with the set screws.
CAUTION: With silicone caulking compound, caulk completely around where the fitter meets
with the post surface to prevent water from seeping into the post.
5. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
6. Restore the frame back to the fitter, then secure it with the bolt nuts.
7. Turn on the power at the main fuse or circuit breaker box.
Frame
Bulb Type A Max.150W
(not included)
Glass Panel
Grounding Wire
Socket
Stud
Bolt Nut
Bolt Nut
Fitter
Fixture Wire
Set Screw
Wire Nut
Post