USER MANUAL MODEL 1015 and 1015S DB-15 Async Short Range Modem Part# 07M1015-B Doc# 024011UB Revised 5/24/94 SALES OFFICE (301) 975-1000 TECHNICAL SUPPORT (301) 975-1007 http://www.patton.
1.0 WARRANTY INFORMATION 2.0 GENERAL INFORMATION Patton Electronics warrants all Model 1015 components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment. This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modification. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above.
.0 CONFIGURATION 4.0 INSTALLATION The Model 1015 is designed to be easy to use. There are no internal jumpers or configuration switches to set, so there is no need to open the case to configure the unit (you may need to open the case for wire connection—refer to section 4.0). However, in some models, you may have to set the external DCE/DTE switch. Once you have properly configured the DCE/DTE switch, you are ready to connect the Model 1015 to your system.
RJ-11 SIGNAL RJ-45 1 ----------------GND† 2 ----------------RCV3 ----------------XMT+ 4 ----------------XMT5 ----------------RCV+ 6 ----------------GND† 1. Open the unit by gently inserting a screwdriver between the DB-15 connector and the lip of the plastic case (see below). You don’t have to worry about breaking the plastic, but be careful not to bend the D-sub connector.
4. Connect one pair of wires to XMT+ and XMT- (transmit positive and negative) on the terminal block, making careful note of which color is positive, and which color is negative. 5. Connect the other pair of wires to RCV+ and RCV- (receive positive and negative) on the terminal block, again making careful note of which color is positive and which color is negative. 8. Place the 2 halves of the strain relief assembly on either side of the telephone wire and press together very lightly.
APPENDIX A 10. TIP the top half of the case as necessary to place it over the strain relief assembly. Do not snap the case together yet. PATTON MOCEL 1015 SPECIFICATIONS Transmission Format: Asynchronous Data Rate: 0 to 19,200 bps (no strapping) Surge Protection: 600W peak power dissipation at 1 mS (10 x 1000 µs exponential waveform) and response time of 1.
APPENDIX B BLOCK DIAGRAM 11
