- Patton VoIP Gateway Router Quick Start Guide

2 SmartNode 4520 and 4110 Quick Start Guide
1.0 Power up the SmartNode
1. Connect the SmartNode to a power source using the included power supply
and cable.
2. When the Power LED stops blinking and remains lit, the SmartNode is ready
to configure.
• The SmartNode contains no user serviceable
parts. The equipment shall be returned to Patton
Electronics for repairs, or repaired by qualified
service personnel.
• Mains Voltage: Do not open the case when the
power cord is connected. For systems without a
power switch, line voltages are present within
the power supply when the power cord is con-
nected. The mains outlet that is utilized to power
the SmartNode router shall be within 10 feet (3
meters) of the device, shall be easily accessible,
and protected by a circuit breaker
• The smartNode is not shipped with power
cables. For AC powered units, ensure that the
power cable used meets all applicable standards
for the country in which it is to be installed, and
that it is connected to a wall outlet which has
earth ground.
• Hazardous network voltages are present in WAN
ports regardless of whether power to the Smart-
Node is ON or OFF. To avoid electric shock, use
caution when near WAN ports. when detaching
the cables, detach the end away from the Smart-
Node first.
• Do not work on the system or connect or discon-
nect cables during periods of lightning activity.
The terminal block header to which the wires are secured pro-
vides the disconnect for the SmartNode. Take proper measures
to ensure that it is not permanently fastened to the receptacle
mounted on the chassis.
WARNING
CAUTION