User Manual

ManualsBrandsPavement Ends ManualsFor the car41518 Sun Cap

41518 pg 1

1206 Rev. 3

Sun Cap

Installation Instructions

For: Jeep Wrangler with or

without Door Surround

2003 – 2006

Part Number: 41518

Table of Contents

SUN CAP PARTS LIST ........................................ PAGE 2

UN CAP TOOLS NEEDED ................................... PAGE 2

UN CAP INSTALLATION ...................................... PAGE 2

UN CAP WARRANTY ......................................... PAGE 5

Summary of content (5 pages)

PAGE 1
Sun Cap Installation Instructions For: Jeep Wrangler with or without Door Surround 2003 – 2006 Part Number: 41518 Table of Contents SUN CAP PARTS LIST ........................................ PAGE 2 SUN CAP TOOLS NEEDED ................................... PAGE 2 SUN CAP INSTALLATION ...................................... PAGE 2 SUN CAP WARRANTY ......................................... PAGE 5 41518 pg 1 1206 Rev.
PAGE 2
Tools Needed Parts List #30 Torx Driver Safety Glasses Sun Cap D-Ring Web Strap Qty - 1 Qty - 2 Step One INSTALL D-RING WEB STRAPS Locate the D-Ring Web Straps in the parts kit. Use the #30 Torx to remove the bolt at the rear of the speaker pod on each side of the vehicle. Thread a bolt through the hole in each D-Ring Web Strap and reinstall the bolts in the holes in the speaker pods. Do not tighten them at this time.
PAGE 3
Step Three FASTEN CENTER STRAP Center Strap - Thread through Footman Loop Wrap the long center strap at the rear of the Sun Cap around the sport bar, pull it forward into the vehicle to the windshield. Thread the strap through the footman loop on the windshield frame. Then pull the end of the strap back and thread it through the buckle. Tighten it securely.
PAGE 4
Step Six - without Door Surrounds FASTEN FLAPS ABOVE DOORS Locate the hook and loop strips sewn to the front corners of the Sun Cap. Fasten the strips to each other and tuck them up above the horizontal sport bar, out of the way. Locate the flap sewn inside the Sun Cap above the door opening. Wrap the inside and outside flaps around the horizontal sport bar and fasten the Hook and Loop Strips to each other. Hook and Loop sewn inside fabric. Wrap Flaps around bar and fasten Hook and Loop to each other.
PAGE 5
Care and Maintenance of your New Sun Cap Your Sun Cap is made of the finest materials available. To keep it looking new and for the maximum possible wear, it will need periodic cleaning and maintenance. Washing: The fabric should be washed often using soap, warm water and a soft bristle brush. Rinse with clear water to remove all traces of soap. Water: In the event of seeping through the seams, 3M Scotchgard® may be applied on the inside of the seams to stop the seepage.