Instruction Manual

41727/41728/41729 pg 2
Parts List
Canopy Cover Fabric Qty - 1
Canopy Cover Installation
Preparing the Vehicle for Installation of the
Canopy Cover
• Make certain that the vehicle engine and all lights are turned off.
• Set the Emergency (Parking) Brake.
• Remove all personal possessions from the vehicle.
Step One
Orient the Canopy Cover with the large elastic loops
toward the back and the web straps on the sides.
Drape the Canopy Cover over the vehicle.
Snap- for 41728 only
attaches to the front
door.
Step Two
Locate the two web straps sewn on each side of the
Canopy Cover. Pull the straps down and hook them
to the bottom of the vehicle. Tighten the straps by
pulling up the disengaged buckle. Secure the buckle
by flipping the tab of the buckle down.
For the late YJ model (41728) there is a snap located at
the front of the cover. This can be snapped to the front
door area of the vehicle to give additional security.
Step Three
Locate the three elastic loops sewn to the rear of the
Canopy Cover (one small loop on each side of the
vehicle and one large loop in the center). Hook the two
outside loops around the taillights and hook the center
loop around the tire carrier.
Elastic Loops - Hook
around taillights
Elastic Strap - Hook
around tire carrier
Rev. B 0505
Web Straps Hook
to Bottom of Vehicle
Metal Hook
Body of Vehicle
Web
Buckle
Slide Buckle Up
Flip Tab Down
For ease of installation: Firmly hold web
and buckle up with one hand while engag-
ing the buckle lever down with the other