Instruction Manual

M odel

Thank you for purchasing the PDR product

To ensure the correct usage, please read and follow the instructions

manual thoroughly. Please store the instructions in a safe place

for future reference.

To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the panel

display and the mount.

Always use at least two persons for all installations.

Fully tighten all of the mounting screws as specified in the installation instructions.

Model SWM-050 FEATURES

Special techniques are necessary for installation of the panel display mount.

Do not attempt to perform this work by yourself.

Request an installation specialist to install this unit.

Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.

Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the

mounting unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and

airflow.

Mounts by

A division of David Engineering & Mfg. Inc.

SWING WALL MOUNT SWM-050

All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship.

Check the PDR website for details @ www.PDRmounts.com. We are not liable for improper installation that results in damage

to mounts, adapters or presentation equipment.

sDesigned for a wide variety of displays

s75mm and 100mm VESA mounting pattern

sFingertip tilt-swivel adjustment

sTilts 5 deg up and 15 deg down

sRotates left and right

sIntegrated cable management design

s50 lb load rating

sMade and serviced in the USA

PAGE 1
Mounts by A division of David Engineering & Mfg. Inc. Model SWING WALL MOUNT SWM-050 Thank you for purchasing the PDR product To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference. All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship. Check the PDR website for details @ www.PDRmounts.com.
PAGE 2
INSTALLATION LOCATION WARNING The wall where the wall mount is to be installed must be capable of long-term support of the total load of the display and wall mount. Measures should also be taken to ensure sufficient strength to withstand the force of earthquakes, vi bration and other external forces. Note: Incorrect installation can cause the display to fall and cause injury. Total load of the display ( display + wall mount) MAXIMUM WEIGHT - 50 Lbs. ( 23 Kg.
PAGE 3
PARTS LIST ITEM NO.
PAGE 4
WALL MOUNTING INSTRUCTIONS Determine a suitable mounting position, making sure there is enough room for the mount and display to swing from left to right. The SWM-050 must be mounted centered on a wall stud. See fig 1 Mark the location with a pencil, and using a 3/16 drill bit, drill a pilot hole for the mounting hardware #12 . Secure the top of the bracket with lag screw #12 and washer #13 .