Instruction Manual

the strength of the wood studs is not sufficient, add reinforcement.
Always confirm the center of the stud is used for the installation.
Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any
not install in locations where there are excessive amounts of dust,
Do not block the ventilation holes. Leave sufficient clearance in regard to the surroundings to avoid blocking the ventilation..
The internal temperature could elevate and possibly result in fire. Install the panel (4") or more away from surroundings.
sloped surfaces. Also, do not install facing upward. The internal temperature could
elevate and possibly result in fire. Injury or damage could also result from falling.
Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the panel display
light. Strong light could result in eye fatigue during usage.
Use the specified bolts and screws in the specified places and tighten firmly. Failure to do this could cause injury if the display falls.
could result with injury due to the display falling.
Always use at least two people to perform the installation work. Injury could result from dropping heavy objects.
be installed must be capable of long-term support of the total load of
also be taken to ensure sufficient strength to
bration and other external forces.
display to fall and cause injury.
display + wall mount)
MAXIMUM WEIGHT - 50 Lbs. ( 23 Kg.)
C a u t i o n : I n s t a l l a t i o n o f u n i t i s t o b e c a r r i e d o u t b y q u a l i f i e d t e c h n i c i a n s o n l y . I n s t a l l i n a n a p p r o p r i a t e
location by checking the wall structure and durability for safety and accident prevention.
INSTALLATION LOCATION
INSTALLATION ON A WOODEN WALL
Always install so that the load is supported by a wood stud. If
Do not install on decorative posts or plaster board.
water is possible. These can result in fire or electric shock.
Do not install close to an air conditioner intake or outlet. Do
oily smoke or tobacco smoke. Fire could result.
.
Install only on a vertical surface. Avoid
falling.
Do not install where there is direct sunlight or other strong
Do not alter any of the parts. Do not use broken parts. This
The wall where the wall mount is to
the display and wall mount. Measures should
withstand the force of earthquakes, vi
Note: Incorrect installation can cause the
Total load of the display (
2
CAUTION
WARNING
WARNING
Rev 031507