Instruction Manual

WALL MOUNTING INSTRUCTIONS

DISPLAY MOUNTING INSTRUCTIONS

Place the display face down on a soft protected surface. Using the four screws supplied #15, screw into the back of the display

leaving the head about 1/8” from bottoming.

See fig 3

Place the display onto the mount thru the keyhole slots in the SWM-050 ( # 4). See fig 4

After the display is secure in the bottom of the keyhole slots tighten the screws. See fig 5

Tighten the tension bolts and knob to suite your preference and the weight of the display. This will prevent the mount from creeping

from the desired location . See fig 3

Route the wires thru the holes provided in the mount to suite. See fig 3

(If your display back is not flat it may require the use of the spacer and screws supplied

#11 and #14) .

Determine a suitable mounting position, making sure there is enough room for the mount and display to swing from left to right.

The SWM-050 must be mounted centered on a wall stud. See fig 1

Mark the location with a pencil, and using a 3/16 drill bit, drill a pilot hole for the mounting hardware #12 . Secure the top of the

bracket with lag screw #12 and washer #13 .

Swing the mount to the left or right against the wall, and using a level (not supplied) adjust and secure the bottom hardware #12 and

#13 See fig 2

1/8” approx

Fig 3

Fig 4

Fig 5

Adjustment slot

Level (not supplied)

Fig 1

Fig 2

Hardware #12 & #13

Wall stud

Drywall

Tension bolts

Tension knob

Adjustment slot

Typical wiring

Secure in this position