Owner manual

ManualsBrandsPDR Mounts ManualsAccessories for videoUCMM50

Model

UCMM50 UNDER CABINET MONITOR MOUNT

To ensure the correct usage, please read and follow the instructions

manual thoroughly. Please store the instructions in a safe place

Special techniques are necessary for installation of the panel display mount.

Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.

All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship. We are not liable

for improper installation that results in damage to mounts, adapters or presentation equipment.

Mounts by

A division of David Engineering & Mfg. Inc.

! Suitable for displays with 75mm &

100mm VESA mounting pattern

! Simple to adjust no tools required

! 2”Adjustable height from 6.8” to 8.8”

! 100 deg tilt and 360 deg.

rotation

! Quick monitor removal with exclusive

Features

Thank you for purchasing the PDR monitor mount with the exclusive “Bayonet locking system”

To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to

withstand the weight of both the monitor and the mount.

Quick disconnect lever

Height adjuster

View angle adjuster

Mounting plate

Mounting hardware

Wood screw

Monitor mounting screw

Projector wall mounting application fig 2

360 deg Rotation

for future reference.

Summary of content (4 pages)

PAGE 1
Mounts by A division of David Engineering & Mfg. Inc. Model UCMM50 UNDER CABINET MONITOR MOUNT Thank you for purchasing the PDR monitor mount with the exclusive “Bayonet locking system” To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference. All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship.
PAGE 2
INSTALLATION LOCATION WARNING The cabinet where the mount is to be installed must be capable of long-term support of the total load of the monitor and mount. Measures should be taken to ensure sufficient strength to withstand the force of earthquakes , vibrations and other external forces. Note: Incorrect installation can cause the projector mount to fall and cause injury. Total load of the mount ( monitor + Mount) Maximum weight - 20 Lbs ( 10Kg.
PAGE 3
1 FASTENING THE MOUNTING PLATE TO THE CABINET BOTTOM Using the 4 wood screws supplied, attach the mounting bracket to the underside of the cabinet. Place the narrow end of the plate up against the cabinet front lip. A spacer and longer screws may be required if the lip is deeper than 2”.
PAGE 4
3. MOUNT THE MONITOR ASSEMBLY TO THE CABINET Place the monitor assembly into the bayonet slots on the mount ( small end into large end) and slide forward until the safety lever engages fig 6. Adjust the tri knobs for monitor height and angle for best viewing. To remove, lift the quick disconnect lever and slide the unit backwards and out. NOTE: To store . Rotate the monitor parallel to the front, Loosen the side knob fold up and tighten the tilt knob.