Manual

11
Troubleshooting
The remote control
doesn’t work.
Please check the batteries by removing the cover on the back of the
remote. It is an infrared remote so it needs a clear line of sight to the
sensor on the front panel of the Grand Integrated.
You intermittently lose your
signal on the
USB input.
)LUVWWU\UHODXQFKLQJ\RXUPXVLFVHUYHUSURJUDPL7XQHV:03HWF
If your computer still doesn’t recognize the USB DAC unplug the USB
cable from the computer and the Grand Integrated, wait a few sec-
onds, then reconnect. These are computer hookups, and sometimes
you’ll lose a signal just as with your printer or other USB device. You
should not have this problem often. We designed the Grand Integrated
to remain locked on the USB signal at all times, but signal dropouts
are still possible.
You pick up hum and noise on
your Grand Integrated from
the Computer.
This can require some trial and error diagnostics. If you have music
ÀOHVDYDLODEOHRQDODSWRSFRPSXWHUFRQQHFWLWZKLOHRQEDWWHU\SRZHU
to the Grand Integrated. If it works properly, with no noise, then the
FRPSXWHULQ\RXURIÀFHLVLQWURGXFLQJDJURXQGORRSLQWRWKHV\VWHP
This is not uncommon. However, the Grand Integrated’s digital inputs
are transformer-coupled to minimize this problem. If a problem
persists, please feel free to contact Peachtree Audio.
When you switch from one
source to another you get a
loud “click” or “pop.”
Sometimes this is from static buildup but it should not occur consistently
over a long period of time. Contact your dealer or Peachtree Audio if this
persists.
7KHDPSOLÀHUVKXWVGRZQEXW
the lights are still on.
7KHDPSOLÀHULQWKH*UDQG,QWHJUDWHGZLOOVKXWGRZQLILWH[SHULHQFHV
an unusually large power surge or overheats due to a short, or very
loud volumes over a long period of time. This is a protection circuit.
7XUQGRZQWKHYROXPH7KHDPSOLÀHUVKRXOGFRPHEDFNRQDIWHUD
while.
The Grand Integrated
will not turn on.
Check to be sure that both the power switch on the back panel and the
standby switch on the front panel are on. The front panel light should be
blue. It is green when in standby.
The Grand Integrated
turns on but there is
no sound.
Be sure your system is not muted and that the Grand Integrated
has been selected. Be sure your digital source is on and playing.
Be sure the Grand Integrated’s standby button is glowing blue and that
your desired input is glowing blue. If the input button is blinking
the Grand Integrated is in “mute” mode. Press the mute button on
the remote to un-mute the Grand Integrated. Check to be sure your
digital cable is properly connected.
Grand Integrated