Installation Guide

Suggested Installation for Mantel Shelves using the included Hanger Rail system
The hanger rail is only a suggested method; your installer may have additional methods for mounting your mantel shelf. Always consult a professional.
THANK YOU FOR PURCHASING A
PEARL MANTELS NON-COMBUSTIBLE SHELF!
Included in your carton: Mantel Shelf, Detached Hanger Rail with pre-drilled 2”
offset holes, Instruction Sheet, and Certificate of Authenticity.
Not included: Mounting hardware for detached hanger rail. There are many
different mounting surfaces, i.e. brick, stone, drywall…and each requires a
different hardware for secure attachment. Always consult a professional.
Measuring/Mounting
Always attach hanger rail to studs. Always consult a professional.
Always attach hanger rail to studs.
The Hanger Rail is packed separately in
the carton and will attach to your mounting
surface. When married to the mantel shelf, it
will be locked in place on the wall.
* Mounting hardware for detached hanger rail
is NOT INCLUDED.
Always consult a professional before applying paint or stain.
Always consult a professional.
Measuring: Measure from bottom of the shelf to the bottom of the hanger rail (1)
(See Figure A. below). This measurement is where the bottom of the shelf will be when
mounted on the hanger rail.
Measure and mark center
of Hanger Rail
X
FIREBOX
Always Observe Heat Clearances!
Mark distance
from bottom of
hanger rail to
bottom of shelf
Metal Hanger Rail
Measure this distance
on both right and left sides
Centering: Find center point over firebox by measuring from one side
to the other, mark the center point on mounting surface, do the same
for the hanger rail. (See Figure B. below)
Figure A.
Figure B.
Side View of Shelf
Wall
Mounting
Hardware
(not included)
Hanger
Rail
Back View of Shelf
Shelf
Metal Hanger Rail
Inside Back
Back View
of Shelf
Metal Hanger Rail
Measure from the floor or the hearth to where the bottom edge of the hanger rail will
be, remembering to add the distance to the bottom of the shelf (see Fig. A), and mark
your recorded measurements on the wall both right and left. Center your hanger
rail (see Figure (B), ensure your pilot holes align to studs and mount the hanger rail
so that the bottom of the board is on your recorded marks. Hang your shelf. Some
surfaces may not be flush which may require shims or filling of gaps.
Always consult a professional.
Non-Combustible Shelf
Hanger Rail
Product Patent Pending