Installation Instructions

20
FREIGHT DOORS
I
CAR GATES
I
CAR ENCLOSURES
TECHNICAL SUPPORT 1-800-787-5020 ext 275
THE PEELLE COMPANY
®
Guide No.
Date:
224-EN
WIRELESS CONTROLLER
INSTALLATION & INTERFACE GUIDE
May 13 / 2021
4.0 COMMISSIONING
4.1 CAR DOOR
Make sure all Landing Doors and Car Doors are adjusted and run freely by hand in the door guides without
binding or sticking.
1. Turn power ON
8. Press and hold the CLOSE button to close
the door.
If car door stalls before learn
is complete, set parameter
12 to HD. Re-run the learn
cycle. Adjust speeds to suit
to ensure car door does not
slam.
2. Set AUTO<>IND switch to IND
9. Set AUTO<>IND switch to AUTO.
3. Using the OPEN, CLOSE and RETCAM cam buttons, ensure the car door operator(s) and
retiring cam motor(s) are phased for correct rotation. If a motor rotates in the wrong direction,
switch any two of the three motor wires
4. To begin, cycle through parameters by pressing the - & + buttons. Once the desired parameter
is displayed, press the ENTER button to access the setting for that parameter. Change the setting
by pressing the - & + buttons. Once the desired setting is displayed, press the ENTER button to
save the setting. Parameters can only be modied in IND mode.
5. Change parameter 02 to “Cd” setting.
e LCD display should now read “CAR DOOR”.
If car door stalls during
operation (normal operation
or nudging), set parameter
12 to HD. Adjust speeds to
suit to ensure car door does
not slam.
If retiring cam top assembly
does not completely li
retiring cam bottom
assembly, set parameter 70
to 10.
6. Use parameter 03 default “CHANNEL 15” for the rst car
door . For each additional car door , change parameter 03 to
a dierent channel. e LCD display will show what channel
has been selected.
Tweaks
Tweaks
7. Change parameter 10 to “Lr” setting. Press ENTER to begin
learn cycle. Prior to learn, car door can be in any position. e
learn cycle will fully close and then fully open. Once the car
door is fully open, the learn cycle is complete and the ashing
“LEARN” indicator on the LCD will turn o.
OPEN CLOSE RET
CAM
_
+
ENTER
IND
AUTO
IND
AUTO
CLOSE