Installation Instructions

23
FREIGHT DOORS
I
CAR GATES
I
CAR ENCLOSURES
TECHNICAL SUPPORT 1-800-787-5020 ext 275
THE PEELLE COMPANY
®
Guide No.
Date:
224-EN
WIRELESS CONTROLLER
INSTALLATION & INTERFACE GUIDE
May 13 / 2021
LCD INPUT INDICATORS
5.0 ELEVATOR CONTROLLER INTERFACE
5.1 ELEVATOR TO DOOR CONTROLLER INPUT CONNECTIONS
Control Interface
Inputs to the car door controller are the only interface to the elevator control for door operation. Note: front and
rear inputs are completely separate.
INPUT COM
Add jumper to the INPUT COM from V- when car car door controller V+ is used for the input voltage.
Note: where elevator control voltage is used, connect INPUT COM to elevator controller according to elevator
control prints. Do not use V+ or V-.
DO - Door Open 1
Constant signal required to open doors
DC - Door Close 2
Constant signal required to close doors
SE - Nudging 3
Constant signal required with door close for car door
slow speed closing in re service phase 1 recall.
DCM - Fast Open / Close 4
Constant signal required with door CLOSE for landing
door and car door simultaneous operation.
RC - Retiring Cam 5
Input required to lift cam and move car. Signal
should be low whenever car is stopped.
BUZZ - Close Warning Buzzer 6
Input required 5 seconds before automatic door
close and until doors are fully closed.
AUX2 - 7 For input options see parameters 65/85/88
RE - Reversing Edge 8
DCD0 SE DCM
RC
BUZZ
INPUT
COM
V- V+
AUX2
1
2 3 4 5 6 7
ELEVATOR
CONTROLLER
CLOSE BUZZER
RETIRING CAM
FAST OPEN/CLOSE
NUDGING
DOOR CLOSE
DOOR OPEN
Car Door Controller