Installation Instructions

29
FREIGHT DOORS
I
CAR GATES
I
CAR ENCLOSURES
TECHNICAL SUPPORT 1-800-787-5020 ext 275
THE PEELLE COMPANY
®
Guide No.
Date:
224-EN
WIRELESS CONTROLLER
INSTALLATION & INTERFACE GUIDE
May 13 / 2021
Problem Possible Cause Action
AUTO-IND slider not set to IND Set AUTO-IND slider to IND
See Landing Door motor wiring
See sections "car door encoder" & "retiring cam
motor"
Duty timer for motor has been exceeded. Cool
down period required for motor regeneration. If
condition persists, increase duty timer. See
parameters P72 & P82.
Note: increasing duty timer may shorten motor
life
Check Landing Door motor output or Car Door
selector relay output for short circuit to ground
See page 6 for Landing Door motor wiring
See sections "car door encoder" & "retiring cam
motor"
Acknowledge “OVERLOAD” by setting
parameter P01 to 01
Controller type not set to Car Door (CD) Ensure parameter P02 is set to “CD”
Wiring problem to Car Door selector relay
output
See sections "car door encoder" & "retiring cam
motor"
Slow speed Landing/Car Door
operation only
LCD “LEARN” flashing
Operational profile not learned. Set parameter
P10 to “Lr” to initiate learn sequence
Encoder set screw loose Ensure set screw is tight on encoder shaft
See Landing Door encoder wiring
See Car Door encoder wiring
Move door manually and check that encoder
count on LCD is changing
Ensure bottom assembly moves freely on pivot
pins
Ensure connecting rod is parallel to bottom
assembly (face) and top assembly (motor)
Mechanical problem with top assembly (motor) Ensure pulley belt has 3/4” of deflection
Mechanical problem with full assembly
Ensure when pulling back that pickup arm on
top assembly starts at 6 o’clock and rotates
towards middle of car to either 9 o’clock or 3
o’clock (depending on rotational direction)
Wiring problem to Landing Door motor output
or Car Door selector relay output
No operation from RETCAM
pushbutton
Landing/Car door runs for 12”
then stops
Encoder wiring problem
Mechanical problem with bottom assembly
(face)
Retiring Cam not fully pulling
back
Flashing LCD “OVERLOAD” icon
Constant LCD “OVERLOAD” icon
No operation from
OPEN/CLOSE pushbutton
7.0 TROUBLESHOOTING
7.1 INDEPENDENT MODE
PEELLE ONLY OPERATION - USED FOR COMMISSIONING AND INDIVIDUAL
LANDING/CAR DOOR OPERATION
(AUTO-IND slider switch set to IND)