Installation Instructions

30
FREIGHT DOORS
I
CAR GATES
I
CAR ENCLOSURES
TECHNICAL SUPPORT 1-800-787-5020 ext 275
THE PEELLE COMPANY
®
Guide No.
Date:
224-EN
WIRELESS CONTROLLER
INSTALLATION & INTERFACE GUIDE
May 13 / 2021
Problem Possible Cause Action
Set AUTO-IND slider to AUTO
All controllers must be set to AUTO.
Elevator not in Landing Door zone
Ensure retiring cam bottom assembly is on
Landing Door roller arm
LCD “ZONE” icon not on at either Landing
Door controller or corresponding Car Door
controller
Ensure Input 3 is on at Landing Door controller.
Ensure Landing Door channel matches Car
Door channel. Adjust parameter P03 if
necessary
Ensure Landing Door address is unique and not
set to 00. Adjust parameter P04 if necessary
Constant LCD “EUD” icon = EUD is in STOP
position at current landing
Flashing LCD “EUD” icon = EUD is in STOP
position at another landing on the same channel
LCD “MULTIZONE” icon on at Landing Door
controller and corresponding Car Door
controller
Check all interlock zone micro switches. Only
one zone micro switch can be on at a time on
one channel.
Duty timer for motor has been exceeded. Cool
down period required for motor regeneration. If
condition persists, increase duty timer. See
parameters P72 & P82.
Note: increasing duty timer may shorten motor
life
Check Landing Door motor output or Car Door
selector relay output for short circuit to ground
See page 6 for Landing Door motor wiring
See sections "car door encoder" & "retiring cam
motor"
Acknowledge “OVERLOAD” by setting
parameter P01 to 01
No operation from
OPEN/CLOSE pushbutton
Flashing LCD “OVERLOAD” icon
Constant LCD “OVERLOAD” icon
LCD “EUD” icon on (or flashing) at Landing
Door controller and flashing at corresponding
Car Door controller
LCD “ANTENNA” icon not on (or flashing) at
zoned Landing Door controller or
corresponding Car Door controller
AUTO-IND slider not set to AUTO
7.2 AUTOMATIC MODE
PEELLE ONLY OPERATION - USED FOR COMBINED LANDING AND CAR DOOR
OPERATION
(AUTO-IND slider switch set to AUTO)