Installation Instructions

31
FREIGHT DOORS
I
CAR GATES
I
CAR ENCLOSURES
TECHNICAL SUPPORT 1-800-787-5020 ext 275
THE PEELLE COMPANY
®
Guide No.
Date:
224-EN
WIRELESS CONTROLLER
INSTALLATION & INTERFACE GUIDE
May 13 / 2021
Problem Possible Cause Action
Are LCD input icons on Car Door controller?
If not check the folowing:
Ensure external power reference is wired to
Input Com.
Note: ensure no connections to Peelle V+/V-
Ensure parameter P50 is set to 00.
Ensure input 5 is off on Landing Door
controller. See page 10
See Automatic Mode chart
Door may be mechanically obstructed. Fix
obstruction.
If there is not enough power in slow speed for
final open or final close, increase the following
parameter(s) in multiples of 5 until fixed:
Open direction - P27
Close direction - P48
Elevator controller is sending
outputs to Peelle controller but
no Landing/Car Door operation
in close direction
Light curtain obstructed Check light curtain alignment
Elevator controller is sending
outputs to Peelle controller but
no Landing/Car Door operation
in open or close direction
If Peelle power is used to power Peelle inputs,
missing jumper from Input Com terminal to V–
terminal on Car Door controller
If external power is used to power Peelle inputs,
missing external power reference wire on Input
Com terminal on Car Door controller
Landing/Car door stopped before final
open/close
Add jumper from Input Com to V-.
Landing Door stop input on
7.3 ELEVATOR INTERFACE OPERATION