Installation User guide

Installation and Assembly: Ventilation Maximizing Risers

Models: ACC-FV, ACC-V

ISSUED: 06-08-11 SHEET #: 180-9004-1

Note: Do not begin to install your Peerless product until you have read and understood the instructions and warnings

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call

Peerless Customer Care at 1-800-865-2112.

ACC-FV ACC-V

Description Qty. Part # Part #

foot, black 4 600-0223

velcro circle 8 600-0224 600-0224

adhesive tape 4 570-0053

Parts List

Note: To properly support the HD Flow unit, 4 feet (A) MUST be used for this installation. Choose a location to

install your HD Flow unit. Remove the adhesive tape (C) from its white paper backing and apply adhesive side

down to the approximate areas shown, on either side of the unit, making sure not to obstruct the HD Flow units

venting slots.

VENTING SLOTS

PAGE 1
Installation and Assembly: Ventilation Maximizing Risers Models: ACC-FV, ACC-V Note: Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless Customer Care at 1-800-865-2112. Parts List Description A foot, black B velcro circle C adhesive tape ACC-FV ACC-V Qty.
PAGE 2
Remove red covering from adhesive tape (C). Remove white paper backing from each foot (A) and apply adhesive side of foot (A) to adhesive tape (C). 3 Remove the white paper backing from four velcro circles (B) and apply, adhesive side down, to each foot (A). A C B A 4 Place the remaining four velcro circles (B) onto the circles previously installed so that the white paper backing is facing outward. 5 Note: Double check the desired placement of your HD Flow unit prior to adhesion.