Installation Owner's manual

ISSUED: 10-31-10 SHEET #: 120-9091-2 11-08-10

Parts List

Description Qty. Part #

A accessory bracket 1 201-P1746

Installation and Assembly - A/V Component Shelf Accessory

Bracket Connects DS and VPM component shelves to SA752,

SA761, SA763 or SA771 articulating wall mounts

Models: ACC951

Max Load Capacity: 30 lb (13.7 kg)*

Some parts may appear slightly

different than illustrated.

Before you start make sure all parts listed are included

with your product.

IMPORTANT! Read instruction sheet before you start installation and assembly.

If wall arm (sold separately) has not been

mounted, skip to step 3 on page 2.

Remove two M10 x 15 mm screws from bottom

holes of adapter plate. Loosen two M10 x 15 mm

screws from top holes of adapter plate.

*Combined load of equipment, hardware and

components is not to exceed max load capacity of

wall arm (sold separately)

Unhook universal or dedicated adapter bracket

from adapter plate.

UNIVERSAL

ADAPTER BRACKET

ADAPTER PLATE

REMOVE

M10 X 15 MM SCREWS

LOOSEN

M10 X 15 MM SCREWS

PAGE 1
Installation and Assembly - A/V Component Shelf Accessory Bracket Connects DS and VPM component shelves to SA752, SA761, SA763 or SA771 articulating wall mounts Max Load Capacity: 30 lb (13.7 kg)* IMPORTANT! Read instruction sheet before you start installation and assembly. Before you start make sure all parts listed are included with your product.
PAGE 2
3 Remove two M10 x 15 mm socket screws from universal adapter bracket. Hand thread two M10 x 15 mm socket screws through top slots of accessory bracket (A) into top holes of universal adapter bracket as shown in figure 3.1 leaving 1/8" of exposed thread as shown in detail 1. Hook socket screws onto universal adapter bracket as shown in figure 3.2. fig 3.1 A fig 3.2 1/8" DETAIL 1 2 of 3 Visit the Peerless Web Site at www.peerlessmounts.
PAGE 3
4 Insert two M10 x 15 mm socket screws into bottom mounting holes of adapter plate as shown in figure 4.1. Adjust accessory bracket (A) so bottom tray touches bottom of display and tighten all fasteners using a 6 mm allen wrench included with wall arm. Attach DS or VPM component shelf (sold separately) to bottom tray using M5 screws included with DS or VPM component shelf as shown in figure 4.2. fig 4.1 fig 4.