Manual

3
2015-06-24 #:009-9117-2 (2015-10-13)
Heavy
To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
1
2
+1/2
4
3
Symbols
ENG
WARNING
ENG
x3
Screws must get at
least three full turns
and fi t snug.
ENG
Do not overtighten screws.
ENG
Tools Needed for Assembly.
ENG
Display center.
ENG
ENG - This product is designed to be installed on solid concrete. Hardware is included for solid concrete
installation. Before installing make sure the supporting surface will support the combined load of the equipment
and hardware. Screws must be tightly secured. Do not overtighten screws or damage can occur and product
may fail. Never exceed the Maximum Load Capacity. Always use an assistant or mechanical lifting equipment to
safely lift and position equipment. This product is intended for indoor use only. Use of this product outdoors could
lead to product failure or personal injury. Be careful not to pinch fi ngers when operating the mount. For support
please call customer care at 1-800-865-2112.
WARNING
3/8"
(10mm)
3/8"
(10mm)