Installation User Manual

2 of 12
ISSUED: 05-13-11 SHEET #: 145-9012-8 2013-06-25
Table of Contents
Parts List ..........................................................................................................................................................................3
Installation to Wood Stud Wall .........................................................................................................................................4
Installation to Solid Concrete or Cinder Block ..................................................................................................................5
Installing Tilt Brackets ......................................................................................................................................................6
Display Adjustment .................................................................................................................................................7 and 8
Mounting and Removing Flat Panel Display ........................................................................................................9 and 10
Pull-Out Mount Assembly (Optional) Security ................................................................................................................11
Optional for Multiple Displays: Installing Spacer Kit (Sold Separately) (not Evaluated by UL) ......................................12
NOTE: Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
• studnder("edgetoedge"studnderisrecommended)
• phillips screwdriver
• drill
• 5/16"(8mm)bitforconcreteandcinderblockwall
• 5/32"(4mm)bitforwoodstudwall
• level
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum UL Load Capacity. See page one.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of
an"edgetoedge"studnderishighlyrecommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tightenscrewsrmly,butdonotovertighten.Overtighteningcandamagetheitems,greatlyreducingtheirholding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION HARDWARE REQUIRED
• Wood Stud Included
• Wood Beam Included
• Solid Concrete Included
• Cinder Block Included
WARNING
Accessories
• DS-ACC760 Cable Release Kit
• DS-VWS0## Wall Plate Spacer Kit