Installation User Manual

4 of 12

ISSUED: 05-13-11 SHEET #: 145-9012-8 2013-06-25

WOOD STUD

Installation to Wall Stud

Useastudndertolocatetheedgesofthestud.Useofanedge-to-edgestudnderishighlyrecommended.

Based on their edges, draw a vertical line down the stud center. Place pull-out mount assembly (A) on wall as

a template. Level plate, and mark the center of the four mounting holes. Make sure that the mounting holes are

onthestudcenterline.Drillfour5/32"(4mm)dia.holes2-1/2"(65mm)deep.Makesurethatthepull-outmount

assembly (A)islevel,secureitusingfour#14x2.5"woodscrews(E) and fender washers (G) as shown below.

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all

attached hardware and components.

• Tighten wood screws sothatwallplateisrmlyattached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Makesurethatmountingscrewsareanchoredintothecenterofthestud.Theuseofan"edgetoedge"studnder

is highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).

• When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that the

woods studs are a minimum of 2”x4” nominal size. When installing to more than one stud, insure the spacing be-

tween studs is at least 16” but does not exceed 24”. Do not install over gypsum board thicker than 5/8”.

WARNING