Installation

ManualsBrandsPeerless-AV ManualsMonitorsHG442-HT3-S

ISSUED: 02-28-08 SHEET #: 090-9143-2 04-28-08

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.

1 of 7

Installation and Assembly - Desktop Mount for

Sharp 32

", 37" & 42" HT3 models

IMPORTANT! Read entire instruction sheet before you start installation and assembly.

Models: HG442-HT3,

HG442-HT3-S

• Do not begin to install your Peerless product until you have read and understood the instructions and warnings con-

tained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call

Peerless customer care at 1-800-865-2112.

• This product should only be installed by someone of good mechanical aptitude, has experience with basic building

construction, and fully understands these instructions.

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-

ware and components.

• Never exceed the Maximum Load Capacity.

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding

power.

WARNING

Maximum Load Capacity: 75 lb (34 kg)

Tools Needed for Assembly

• 3M rubber and vinyl #80 spray adhesive (can be purchased at www.3mestore.com/62494949258.html)

• phillips screwdriver

Summary of content (7 pages)

PAGE 1
Installation and Assembly - Desktop Mount for Sharp 32", 37" & 42" HT3 models Models: HG442-HT3, HG442-HT3-S IMPORTANT! Read entire instruction sheet before you start installation and assembly. Maximum Load Capacity: 75 lb (34 kg) WARNING • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet.
PAGE 2
Before you begin, mak e sure all parts shown are included with your product. A Parts List A B C D E F G H I J K L Qty.
PAGE 3
Swivel Restriction Option 1 Mounting plate (A) can be restricted to 60, 120 or 180 degrees of swivel. Locate the swivel hole patterns according to screen model as shown in fig. 1.1. Insert two M5 x 8 mm screws (F) into holes on left and right side for desired degree of swivel restriction as shown in fig. 1.2. 120° 60° 60° 120° 180° 180° Models: LC-32HT3U, LC-37HT3U Models: LC-42HT3U F fig 1.1 EXAMPLE: INSTALLED IN HOLES FOR 180° SWIVEL RESTRICTION A fig 1.
PAGE 4
NOTE FOR LC-32HT3U: Remove rubber pads from bottom of LCD stand that come in contact with mounting plate to ensure a flush fit. 2 LCD STAND MAY APPEAR DIFFERENT THAN ILLUSTRATED Choose the correct mounting hole pattern shown in figure 2.1 for attaching mounting plate (A) to LCD stand. Attach mounting plate (A) to LCD stand using the appropriate number of M6 x 30 mm phillips screws (D) and spacers (C) as shown in figure 2.2.
PAGE 5
3-1 NOTE: Race assembly (B) and rivet must be in the correct orientation when installing. Rotate bottom of race assembly (B) until rivet is in the correct position for screen and desired swivel restriction as shown in as shown in fig. 3.1 and 3.2. Place race assembly (B) onto mounting plate (A) while keeping it in the correct orientation. Attach race assembly (B) to mounting plate (A) using M5 x 6 mm type F phillips screws (E) as shown in fig. 3.3.
PAGE 6
WARNING • Once race assembly (B) is attached to desk surface, swivel restriction/ orientation of screen cannot be adjusted. 3 Before applying vinyl #80 spray adhesive to desk surface, place LCD stand right side up in desired location. Rivet location on race assembly (B) must be in the middle of swivel restriction range, refer to fig. 1.1 on page 3. Rotate stand and verify that swivel restriction is correct.
PAGE 7
4 NOTE: Carefully place screen on LCD stand to reduce the change of displacing it before fully cured. Slide screen onto LCD stand until screen mounting holes and LCD stand mounting holes align as shown in fig. 5.1. Attach screen to LCD stand using fasteners that come with your screen.