Installation and Assembly: Desktop Mount with Desk Clamp and Grommet for 19" - 30" LCD Screens Models: LCT420A, LCT620A LCT420A LCT620A Max Load Capacity: 15 lbs (6.8 kg) 2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerlessmounts.
NOTE: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer care at 1-800-865-2112.
Before you begin, make sure all parts shown are included with your product. Parts List A B C D E F G H I J K L M LCT420A Qty 1 1 1 2 2 4 4 4 1 1 1 5 1 Description column assembly single link arm assembly double link arm assembly grommet assembly round rubber pads square rubber pads M4 x 12 mm phillips screw M4 x 25 mm phillips screw spacer 4 mm allen wrench 2.
Clamp Installation Method 1 Grommet Installation Method 1 Apply four rubber pads (D, E) to bottom of column assembly (A) as shown below. Attach column assembly (A) to mounting surface with a maximum thickness of 3". Skip to step four. Remove clamp assembly from column assembly (A) as shown in figure 1.1. Remove mounting plate from grommet assembly (C) and attach to column assembly (A) with four M6 x 8 mm screws using 4 mm allen wrench (I) as shown in figure 1.2. fig. 1.1 A A M6 X 8 MM SCREWS fig. 1.
Attaching Adapter Plate to Screen WARNING • Tighten screws so adapter plate is firmly attached. Do not tighten with excessive force. Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque. • If screws don't get three complete turns into the screen inserts or if screws bottom out and arm is still not tightly secured, damage may occur to screen or product may fail.
5 Loosen and position lock collar to desired height and retighten lock collar as shown in figure 5.1. Insert arm assembly (B) onto column assembly (A) and let it rest on lock collar as shown in figure 5.2. Tighten set screw on rear of arm assembly (B) using 2.5 mm allen wrench (J) as shown in figure 5.3. fig. 5.1 fig. 5.2 fig. 5.3 B LOCK COLLAR A LOCK COLLAR SET SCREW 6 Hook adapter plate onto arm assembly (B).
Cables may be routed using cavity in arm assembly (B) and cable clip (K). Remove the cable cover on arm assembly (B) by pressing firmly in the middle of the cable cover and then pulling the flanges of the cable cover. Route the cables in arm assembly (B) and then reinstall the cable cover. B FLANGES B CABLE COVER CABLES K 8 K To lock down rotation, tighten set screw shown in detail 2. To lock down tilt, tighten screw shown in detail 3. To lock down swivel, tighten screw shown in detail 4.
LIMITED FIVE-YEAR WARRANTY Peerless Industries, Inc. (“Peerless”) warrants to original end-users of Peerless® products will be free from defects in material and workmanship, under normal use, for a period of five years from the date of purchase by the original end-user (but in no case longer than six years after the date of the product’s manufacture). At its option, Peerless will repair or replace, or refund the purchase price of, any product which fails to conform with this warranty.
