Install Instructions

E. LIGHTING & OPERATING PROCEDURES
57
START-UP PROCEDURE
FOR YOUR SAFETY
READ BEFORE OPERATING
OPERATING INSTRUCTIONS
1. STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition
device which automatically lights the burner.
Do not try to light the burner by hand.
5. Turn gas shutoff valve clockwise
to "OFF".
Handle will be perpendicular to pipe, do not force.
6. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow "B" in the safety
information above on this label. If you don’t smell
gas, go to the next step.
7. Turn gas shutoff valve counterclockwise
to "ON". Handle will be in line with the pipe.
8. Turn on all electric power to appliance.
9. Set thermostat to desired setting.
10. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance"
and call your service technician or gas supplier.
TO TURN OFF GA S TO APPLIANCE
Gas Control Knob
(show in the “OFF”
position)
A. This appliance does not have a pilot. It is
equipped with an ignition device which
automatically lights the burner. Do not
try to
light the burner by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU DO SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch;
do not use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to turn the gas control
valve. Never use tools. If the handle will not
turn by hand, don’t try to repair it, call a
qualified service technician. Force or
attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance
if service is to be performed.
3. Turn the gas shutoff valve clockwise
"OFF".
Handle will be perpendicular to pipe, do not
force.
9474 REV 0
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury, or loss of life.
(PF)
Figure 9.1: Lighting & Operating Instructions