User's Manual

C3648M (7/08) 17

CONNECTING THE DX8100HDDI TO THE DX8100

Refer to Figure 13 to perform the following steps:

1. Plug one end of the VHDCI-to-VHDCI SCSI cable into port CH 1/A on the DX8100-ISCI SCSI card.

2. Plug the other end of the SCSI cable to the DX8100HDDI CH0-In connector.

3. Insert both DX8100HDDI power supply cords in to the unit and plug the cords in to a wall socket.

Figure 13. DX8100 to DX8100HDDI SCSI Connection

TURNING ON THE DX8100HDDI AND THE DX8100

1. Turn on both DX8100HDDI power supplies (refer to Figure 13) and verify that “Ready” is displayed on the LCD.

NOTE: You must wait until the DX8100HDDI displays the Ready status before turning on the DX8100.

Figure 14. DX8100HDDI in Ready Status

2. Turn on the DX8100. The application starts automatically and begins recording data to the DX8100’s internal storage (unless disabled) and

to the DX8100HDDI.

DX8100HDDI

DX8100

IN1 IN2 IN3 IN4 IN5 IN6 IN7 IN8 IN9 IN10 IN11 IN12 IN13 IN14 IN15 IN16

OUT16OUT15OUT14OUT13OUT12OUT11OUT10OUT9OUT8OUT7OUT6OUT5OUT4OUT3OUT2OUT1

ALARMINPUTS RELAY OUTPUTS

1 2245678GND

9 10111213141516

1 2245678GND

9 10111213141516

OPENOPEN

Pull out Fan Only

OPENOPEN

Pull out Fan Only

OPENOPEN

Pull out Fan Only

CH0-Out

CH1-Out

1. Ready

2. Hst Bsy

3. Dry Bsy

4. C_Dirty

5. BBU Fail

COM

CH0-In CH1-In

SCSI CABLE

ESC ENT

PWR

BUSY

ATTEN

MUTE