User's Manual

C3648M (7/08) 27
6. At the command prompt, type telnet and the DX8100HDDI’s IP address obtained in step 4c, and then press Enter.
Figure 30. Entering the Telnet IP Address
7. When prompted for the password, press Enter again.
8. Press Esc on the keyboard to close any messages.
9. Select PC Graphic <ANSI Mode>, and then press Enter.
Figure 31. PC Graphic ANSI Mode
10. Unmap all partitions:
a. Select “view and edit Host luns,” and then press Enter. A shortcut menu opens and “CHL 0 ID 0” is highlighted.
b. Press Enter to select “CHL 0 ID 0."
c. Press Enter. When prompted to unmap Host Lun, choose Yes, and then press Enter again.
d. Repeat step 10c until all active partitions are unmapped.