User's Manual

C3648M (7/08) 29
a. Verify that the active Logical Drive is selected, and then press Enter.
b. Choose “Delete logical drive,” and then press Enter.
Figure 34. Delete Logical Drive
c. Select Yes on the shortcut menu, and then press Enter.
13. On the keyboard, press Esc twice to return to the Main Menu.
INSTALLING THE NEW HDDS
NOTE: You do not have to shut down the DX8100HDDI to install the new hard drives.
14. Install the new HDDs in the DX8100HDDI drive bays. For information about installing HDDs, refer to Installing the DX8100HDDI Drive Trays
on page 15.
15. Verify that the DX8100HDDI status LEDs are flashing green and blue, indicating the drives are ready to be configured.
CREATING THE LOGICAL DRIVE
16. To access the Setup mode from the DX8100HDDI front panel:
a. If the IP address is still displayed in the LCD, press ESC five times.
b. Press and hold ENT for two seconds.
17. Press ENT to enter the Quick Logical Drive Install menu.
18. Press the down arrow to select RAID5.
Figure 35. Quick Logical Drive Install
ESC ENT
PWR
BUSY
ATTEN
MUTE